推荐设备MORE

Radiator automatic temperature contro

Radiator automatic temperature contro

Industry news

The temperature and pressure safety valve stem produced by t

日期:2018-01-12
我要分享
The temperature and pressure safety valve stem produced by the temperature control company is drawn up as a whole, never leaking, corrosion resistant, and stamping. The coating is SGS certified for special environmental protection material. The imported temperature and pressure safety valve is all applied to this technology, not only for its beautiful appearance, but also for its heavy duty of temperature, pressure and safety valve.
Jingcheng temperature control company is a professional manufacturing company dedicated to the field of temperature control. It has a professional team, which guarantees the stability and accuracy of product temperature and pressure.
The temperature and pressure safety valve of the product temperature control company is synchronized with the Watts safety valve technology in the United States.
Automatically close the temperature pressure safety valve. It is suitable for the water heater. The heat value is up to 100000BTU/ hours.
2 and 1 temperature pressure safety valves provide the lowest cost and the most effective protection scheme for high temperature and excessive pressure. A full automatic temperature reduction and pressure reduction protection for hot water containers and hot water heaters with a heat value of 100000 BTU/ hours. A series of 10L configuration test rods and short temperature control rods are applied to the threaded holes directly installed in the container. A series of 100XL configuration test rods and lengthened temperature control rods are suitable for installing on the hot water outlet pipe or directly installed on the threaded hole of the container. The temperature control rod must be immersed in the water and the distance from the top of the container must be within 152mm. The import is external thread, and the export is internal thread. The temperature setting is set to 99oC. standard pressure to be set to 75100125150 psi (5.27, 7.03, 8.79, 10.55 bar).
Characteristic:
1. series of 1L, 1XL, 10L and 100XL- path DN20, (ASME authentication *, CSA certification), with a special temperature control rod coated with special hot melt adhesive
2. full copper valve body
3. stainless steel spring
4. the temperature control rod is accurate and reliable.
Specification:
Temperature and pressure relief valve, each water heater and storage hot water container shall be equipped with CSA certification and ASME certified automatic temperature and pressure relief valve. The protection of water heater will not be too high and the temperature is too high. This product should be certified by ANSI Z21.22. The BTU discharge capacity of this product should exceed the rated input of the water heater for BTU.
Warning: after installation, the owner of the hot water container must operate the stem at least once a year to ensure the smooth flow of the water. Some naturally occurring mineral deposits may stick to the valve, causing the valve to not work properly. When manually operating the stem, water will be excreted, so preventive measures must be taken to avoid contact with hot water and to avoid damage caused by water. Before operating the valve stem, check whether the drain pipe connecting the valve guides the hot water from the valve to the proper place, otherwise it may cause personal injury. If there is no water outflow, the valve does not work. In this case, please turn off the heater immediately and call the maintenance worker. This device is used for emergency safety and temperature reduction and can not be used as an operating control device. Important note: please contact the local government authorities to understand the local installation requirements.
Parameters: setting pressure (MPa): 0.5, 0.6, 0.7, 0.86, 1